NF CA-261F2/CA-206L2 CA系列低噪声差分放大器 - 精密差分放大器 - 力高捷创仪器-日本岩崎总代理BH分析仪-CS半导体参数分析-双脉冲动态-PEM罗氏线圈-N4L环路分析仪-PMK FF1500光隔离探头

NF CA-261F2/CA-206L2 CA系列低噪声差分放大器

产品型号：CA-261F2/CA-206L2 原产地：日本

所属类别：精密差分放大器

产品简介：

CA-461F2 is a low noise differential amplifier which is realized input referred noise voltage density 1.5nV/√Hz and voltage gain 100 times. The CA-461F2 is not only realized low noise but also excellent DC characteristics (0.3µV/ºC) and frequency response (DC to 200kHz) by using low noise circuit of negative feedback technology. Low noise characteristics is performed low signal source impedance(less than 500 ohm). High precision signal processing and high density mounting are possible for using 20 pin single-inline package which has 6 surface strict shield

产品特点

产品参数

应用说明

功能配置

资源下载

CA-261F2

CA-206L2

这是一种只用很少的外接零部件，就能构成的高精度、低噪声的放大器模块。

型号	产品名称	输入形式	电压增益	频率特性	输入折算噪声
CA-261F2	低噪声放大器	不平衡/ 单极接地	40dB ±0.2dB	DC ∼ 200kHz	0.8n/√Hz (typ.)

CA-271F4	低噪声FET 放大器	不平衡/ 单极接地		DC ∼ 10MHz	1.6n/√Hz (typ.)

CA-461F2	低噪声差分放大器	差分		DC ∼ 200kHz	1.5n/√Hz (typ.)

CA-471F4	低噪声FET 差分放大器	差分		DC ∼ 10MHz	2.5n/√Hz (typ.)

电源电压: ±15V

外形: : 67 x 10.5 x 20 (mm), 6面密封, 20引脚SIP

型号	产品名称	输入形式	增益	频率特性	频率带宽	最大输出电压	最大. 输出电流

CA-102R3	高速倒相放大器	根据Rin	根据外接的2个电阻(Rin,Rnf)	DC ∼ 10MHz	DC∼ 1MHz	±10V	±10
CA-206L2	可编程增益放大器	不平衡/单极接地	1, 2, 5, 10, 20, 50, 100倍	DC ∼ 500kHz	DC ∼ 100kHz		±5mA
CA-406L2	差分放大器	差分放大器差分		DC ∼ 200kHz

电源电压: ±15V

外形: CA-102R3 : 32 x 13.3 x 4.0, 12引脚SIP
CA-206L2 : 51.5 x 14 x 5.5, 20引脚SIP
CA-406L2 : 51.5 x 14 x 6.5, 20引脚SIP

Low noise : 1.5nV/√Hz

High CMRR : 100dB or greater

Good DC response : 0.3µV/ºC

Wide band : DC to 200kHz*

High gain : x100

Single in-line package with 6 surface strict shield

Absolute rating
Supply voltage(±Vs)	± 16.5V
Signal input voltage
Differential input	± 1V, ±0.7V (at power off)
Common input	±Vs,±0.7V (at power off)
Offset input voltage	± Vs
Input
Input type	DC coupling, Balanced differential input
Differential input impedance	100k ohm (typ) within 5%@DC(single ended)
Differential input impedance	Parallel capacitance 80pF(typ)
Common input impedance	500k ohm;(typ) @DC
Common input impedance	Parallel capacitance 130pF(typ)
Linear max. differential input voltage	±100mV @1kHz
Linear max. common input voltage	±10V @1kHz
Input bias current	±30nA(typ)
Input offset current	±7nA(typ)
CMRR(input referred)	100dB or greater 120dB(typ)@60Hz
Input referred noise voltage density	1.8nV/√Hz or less @1kHz (inputshort circuit)
Input referred noise voltage density	1.5nV/ √Hz (typ) @1kHz(input short circuit)
Input referred noise current density	2.5pA/√Hz (typ) @10kHz
Input referred offset voltage	±40µV(typ)(input short circuit)
Input referred offset voltage	Possible to adjust zero by external trimmerpotentiometer
Input referred DC drift	±0.3µV /ºC(typ)(input short circuit) 0 to 40ºC
Output
Output type	Unbalanced single ended output
Max output voltage	±10V @1kHz (load R ≥1k ohm)
Max output current	±10mA
Slew rate	10V/µs (typ)
Output impedance	within 50W±5% @DC
Amplifier
Voltage gain	within 40±0.2dB @1kHz
Voltage gain frequency range	DC to 200kHz within +0.5/-3dB
Harmonic distortion	0.006% (typ) @1kHz±10Voutput
Power requirements
Recommended supply voltage	±15V±1V
Consumption current	±30mA or less, ±22mA(typ)
Circumstances
Temperature and humidity range	-20 to 70ºC 10 to 90%RH
Operating Storage	-30 to 80ºC 10 to 80%RH
Outer dimensions
Outline	SS 20 type(20 pins shielded SIP)
Outer dimensions	67 x 10.5 x 20mm not including projection
Weight(NET)	Approx. 20g